Connecting The Telephone To The G450; Connecting An Isdn Bri Station; Connecting One Isdn Bri Station To One Isdn Port; Connecting Two Isdn Bri Stations To One Isdn Port - Avaya G450 Installing And Upgrading

Connecting the telephone to the G450

1. Wire a telephone port to a port on the switch connected to the G450 LAN port.If the switch
is a PoE switch, you do not need to plug the IP telephone into a power supply.
2. Plug the telephone into the telephone port.
3. If the IP telephone will be powered independently, plug the IP telephone into a power
supply and check that the IP telephone is powered up.

Connecting an ISDN BRI station

Each ISDN port on the MM720 Media Module supports up to two ISDN BRI stations.
Note:
The MM720 BRI Media Module cannot be administered to support both BRI
Note:
trunks and BRI stations at the same time. However, the MM720 BRI Media
Module supports combining both B-channels together to form a 128-kbps
channel. CM 3.1 enables combining B-channels, using BONDing, to form a
higher bandwidth connection.
Finally, if the MM720 BRI Media Module is administered to support BRI stations, it
cannot be used as a clock synchronization source.

Connecting one ISDN BRI station to one ISDN port

Connect the station via a standard 8-pin BRI cable to one of the ISDN ports on an MM720
Media Module.

Connecting two ISDN BRI stations to one ISDN port

1. Connect each station to an RJ-45 splitter that provides two RJ-45 4-pair jacks, and one
RJ-45 male connector. See
2. Connect the male connector of the splitter to one of the ISDN ports on an MM720 Media
Module.
Step 1: Connecting data and voice devices
Figure 9 for the correct wiring for the splitter.
Issue 2 June 2008 49