Honda 954 Service Manual page 475

I
Install the combination meter onto the bracket.
nation meter case
bosses w/?h the
Install and tighten the mounting screw.
meter bracke?.
Connect the combination meter multi-connector.
Install the bank angle sensor (page 5-86)
Install the upper cowl (page 2-6).
VOLTAGE INSPECTION
Open and support the front end of the fuel tank (page
3-4).
Disconnect the speed sensor 3P (Natural) connector
and check for loose or poor contact of the connector.
With the ignition switch turned t o "ON" and measure
the voltage at the 3P (Natural) connector of the wire
harness side.
Connection: Black/Brown
Standard:
If there
ness.
-
(+)
Battery voltage
no voltage, repair or replace the wire har-
I S
SCREW
COMBINATION METER
M U LTI-CO'N N ECTOR
3P (NATURAL) CONNECTOR