Honda 954 Service Manual page 15

GENERAL INFORMATION
TORQUE VALUES
FASTENER TYPE
5 m m hex bolt and nut
12 m m hex bolt and nut
Torque specifications listed below are for important fasteners.
Others should be tightened
NOTES: 1. Apply sealant to the threads.
2. Apply a locking agent t o the threads.
3. Apply grease t o the threads.
4. Stake.
5. Apply oil to the threads and flange surface.
6. Apply clean engine oil t o the O-ring.
7. U-nut
8. ALOC bolt: replace with a new one.
9. CT bolt
10. Apply molybdenum disulfide oil t o the threads and seating surface (after removing anti-rust oil additive).
ENGINE
MAINTENANCE:
Spark plug
Timing hole cap
Oil drain bolt
Oil filter cartridge
LUBRICATION SYSTEM:
Oil cooler mounting bolt
Oil pump assembly flange bolt
Oil pump driven sprocket bolt
Oil pressure switch
Oil pressure switch wire terminal screw
Lower crankcase 20 rnm sealing bolt
FUEL SYSTEM (Programmed Fuel Injection):
ECT (Engine Coolant Temperature)/thermo sensor
Throttle body insulator band screw
Throttle cable bracket mounting bolt
Fuel pipe mounting bolt
Pressure regulator mounting bolt
Starter valve synchronization plate screw
Fast idle wax unit link plate screw
Fast idle wax unit mounting screw
Starter valve lock nut
COOLING SYSTEM:
Water pump cover flange bolt
Thermostat cover flange bolt
ENGINE MOUNTING:
Drive sprocket special bolt
1-12
TORQUE
5 (0.5, 3.6)
34 (3.5, 25)
54 (5.5, 40)
standard torque values listed above.
to
ITEM
FASTENER TYPE
5 mm screw
small flange)
6 mm flange bolt (8 m m head,
large flange)
,
45
12
20
20
6
6
PT 118
4
20
12
5
5
6
6
3
3
6
2 6
2 6
1
TORQUE
4 (0.4, 2.9)
12 (1.2, 9)
TORQUE REMARKS
12 (1.2, 9)
NOTE 3
18 (1.8, 13)
29 (3.0, 22)
NOTE 6
26 (2.7, 20)
74 (7.5, 54)
NOTE 9
8 (0.8, 5.8)
15 (1.5, 11) NOTE 2
NOTE 1
12 (1.2, 9)
2 (0.2, 1.4)
29 (3.0, 22) NOTE 2
23 (2.3, 17)
See page 1-14
3 (0.35, 2.5)
1 (0.09, 0.7)
1 (0.09, 0.7)
5 (0.5, 3.6)
2 (0.18, 1.3)
12 (1.2, 9) NOTE 9
NOTE 9
12 (1.2, 9)
54 (5.5, 40)