Honda 954 Service Manual page 476

Remove the upper cowl (page 2-51.
Check for loose or poor connection of the combina-
tion meter multi-connector.
With the ignition switch turned t o "ON" and measure
the voltage at the multi-connector terminals.
Connection: BlacklBrown
Standard:
If there is no voltage, repair or replace the wire har-
ness.
OUTPUT SIGNAL INSPECTION
With the ignition switch is
the Pink/Green wire between the speed sensor con-
nector and combination meter multi-connector.
There should be continuity
If there is n o continuity, repair or replace the wire har-
ness.
Support the motorcycle securely and place the rear
wheel off the ground.
Shift the transmission into neutral.
Connect the speed sensor 3P (Natural) connector.
Measure the voltage at the combination meter termi-
nals with the ignition switch is ON while slowly turn-
ing the rear wheel by hand.
CONNECTION: Pink/Green
STANDARD:
If the measurement is out of specification, inspect the
open circuit i n wire harness.
RE MOVAL/I NSTALLATIO N
Remove the fuel tank (page 5-59).
Disconnect the speed sensor 3P (Natural) connector.
19-10
-
(+)
Battery voltage
OFF, check for continuity of
-
(+)
Repeat 0 to
MULTI-CONNECTOR