Note - Honda 954 Service Manual

Install the shims and insulated washer onto the arma-
Install the insula-
tors
properly as
ture shaft.
noted during
Install a new seal ring onto the motor case.
removal.
Apply grease t o the oil seal lip and needle bearing i n
the front cover.
Install the lock washer onto the front cover.
Install the front cover.
Install the new O-rings onto the motor case bolts.
Install and tighten the case bolts securely.
INSTALLATION
Coat a new O-ring with oil and install it into the starter
motor groove.
Install the starter motor into the crankcase.
Route the starter motor cable and ground cable.
Be Install the ground cable and mounting bolts, and
careful not to
tighten the bolts securely.
damage the water
hose.
Install the starter motor cable, then tighten the termi-
nal nut t o the specified torque
TORQUE: 12
Install the rubber cap securely.
(1.2 kgf-m, Slbf-ft)
ELECTRIC STARTER
SHIMS LOCK WASHER
CA S E B O LT S
18-9