Honda 954 Service Manual page 320

CRAN KCAS E/PISTON/CY LlN DER
Install the bearing caps and connecting rods on a cor-
rect crankpins, and tighten the cap nuts to the speci-
fied torque.
Remove the connecting rod caps and measure the
compressed plastigauge on each crankpin.
SERVICE LIMIT:
If the connecting rod bearing clearance is beyond tol-
erance, selects replacement bearing.
Record the connecting rod I.D. code number (1,2 or 3)
or measure the I.D. with the bearing cap installed
without bearing inserts.
If you are replacing the crankshaft, record the corre-
Letters (A, 5 or
on the crank
sponding crankpin
weight are the
If you are reusing the crankshaft, measure the
crankpin O.D. with the micrometer.
starting from the
35 (3.6 26
0.062 mm (0.0024 in)
O.D.
code letter (A, or C ) .
CONNECTING ROD I.D. CODE