Note - Honda 954 Service Manual

FRONT WHEEL/SUSPENSlON/STEEi?ING
Install the ball race remover into the head pipe as
shown.
Align bearing remover A with the groove i n the steer-
ing head.
Lightly tighten nut B w i t h a wrench.
Note the instaiia-
the assembly
Holding the driver shaft with a wrench, turn nut A
base.
gradually t o remove the upper outer race.
Install ball race remover B as shown and remove the
lower outer race using the same procedure as for the
upper outer race.
Align the bearing remover with the groove in the
steering head.
13-28
BEARING
REMOVER A
DRIVER M E NT
DRIVER ATTACH M E NT
REMOVER B
LO
RACE
D R I V E R ATTACH M E N T
DRIVER SHAFT
DRIVER SHAFT
B
ASSE M B LY
BASE