Honda 954 Service Manual page 379

SERVICE INFORMATION
TROUBLESHOOTING
REAR WHEEL
SERVICE INFQRMATION
GENERAL
A contaminated brake disc or pad reduces stopping power. Discard contaminated pads and clean a contaminated disc
with a high quality brake degreasing agent.
After rear wheel installation, check the brake operation by applying the brake pedal.
The shock absorber contains nitrogen under high pressure.
Before disposal of the shock absorber, release the nitrogen (page 74-13).
When servicing the rear wheel, support
Refer to section 15 for brake system information.
Use only tires marked "TUBELESS" and tubeless valves on rims marked "TUBELESS TIRE APPLICABLE".
Use genuine Honda replacement bolts and nuts for all suspension pivot and mounting point.
SPECIFICATIONS
Minimum tire tread depth
Cold tire pressure
Up to 90 kg (200 Ib) load
Up to maximum weight capacity
Axle runout
Wheel rim runout Radial
Axial
Wheel balance weight
Drive chain
Slack
Shock absorber
Spring adjuster standard position
Tension adjuster initial setting
Compression adjuster initial setting
14.
14-1
14-2
14-3
the
motorcycle using a safety stand or hoist.
ITEM
DID
SUSPENSION LINKAGE
SHOCK ABSORBER
Do
not allow fire or heat near the shock absorber.
STANDARD
290 kPa (2.90 kgf/cm2, 42 psi)
290 kPa (2.90 kgf/cm2, 42 psi)
DID 50VA8C1/108
-
40 50 (1.6 - 2.0)
4th groove
2 turns from full hard
2 turns from full hard
14-9
14-1 1
14-14
Unit: m m (ir
LIMIT
SERVICE
2.0 (0.08)
-
0.20 (0.008)
2.0 (0.08)
2.0 (0.08)
60 (2.1 max.
-
50 (2.0)