Note - Honda 954 Service Manual

ELECTRIC STARTER
Install the brushes into the brush holder.
Install the cable terminal and brush holder into the
Install the following:
- N e w O-ring
-
Insulators
-
Washer
-
Nut
Install the armature in the motor case.
When installing the armature into the motor case,
hold the armature tightly t o keep the magnet of the
case f r o m pulling the armature against it.
The coil may be damaged if the magnet
armature against the case.
Install the same number
as noted during disassembly.
Install a new seal ring onto the motor case.
Apply a thin coat of grease to the armature shaft end.
Install the rear cover, while pushing in the brushes
into the brush holder and aligning the brush holder
tab w i t h the motor case groove.
8-8
pulls
of
shims in the same location
ALIGN
the
MOTOR CASE
ARM ATU RE
I N S U LATORS
UT
WASHER
\
ARMATURE
SHIM