Honda 954 Service Manual page 353

INSPECTION
Axle
Set the axle in V-block and measure the runout,
Actual runout is 1/2 the total indicator reading.
SERVICE
Wheel bearing
Turn the inner race of each bearing w i t h y o u r finger.
The bearings should turn smoothly and quietly.
Also check that the bearing outer race fits tightly i n
the hub.
Remove and discard the bearings if they do
the bear-
ings in pairs. smoothly, quietly, or if they fit loosely in the hub.
Install the new bearings into the hub using t h e special
tools (page 13-12).
Wheel rim runout
Check the r i m runout by placing the wheel in a true-
ing stand.
Spin the wheel by hand, and read the runout using a
dial indicator.
Actual runout
SERVICE LIMITS:
Radial: 2.0 mm (0.08 in)
Axial:
Wheel balance
For optimum
baiance, the tire
Wheel balance directly affects the stability, handling
balance mark
and overall safety of the motorcycle. Always check
iocated next to
the vaive stem
Remount the tire
if necessary
LIMIT:
0.20 m m (0.008 in)
is
2.0 m m (0.08 in)
FRONT WHEEL/SUSPENSlON/STEERlNG
turn
not
WHEEL B EARING
13-11