Place the rear wheel into the swingarm.
Install the drive chain over the driven sprocket.
Install the drive chain adjusting plate and axle f r o m
t h e left side.
Install the drive chain adjusting plate and axle nut.
Adjust the drive chain stack (page 3-20).
Tighten the axle nut t o the specified torque.
TORQUE:
REMOVAL
Support the motorcycle using a hoist or equivalent,
and raise the rear wheel off the ground.
Remove the muffler and exhaust pipe (page 2-13).
Remove the exhaust pipe mounting collar and mount-
i n g rubber.
Remove the following:
- Shock arm plate boltshuts
- Shock arm plates
- Shock link b o l t h u t
- Shock link
INSPECTION
Check that the suspension linkage components for
damage, replace any damaged components.
REAR WHEEL/SUSPENSIQN