Ignition Switch - Honda 954 Service Manual

IGNITION SWITCH

INSPECTION
Remove the air cleaner housing (page 5-64).
Disconnect the ignition switch wire 4P (Natural) con-
n ect o r.
Check for continuity between the wire terminals of the
ignition switch 4P (Natural) connector in each switch
position.
Continuity should exist between the color coded
wires as follows:
IGNITION SWITCH
OFF
LOCK
LEADCOLOR
Remove the air cleaner housing (page 5-64).
Release the connector boot f r o m the wire clamp.
Disconnect the ignition switch wire 4P (Natural) con-
nector.
Remove the top bridge (page 13-5).
Remove the bolts and ignition switch.
Install the ignition switch t o the top bridge.
Install the new main switch mounting bolts and tight-
en the bolts to the specified torque.
TORQUE:
19-16
I
I
I
P
26 N*m (2.7 20 Ibf-ft)
4P (NATURAL) CONNECTOR
KEY OFF
KEY OFF
LOCK PIN
-
R
I
IGNITION SWITCH
\
IGNITIO N SWITCH
CLAMP
\