Honda 954 Service Manual page 92

COMPRESSION AND REBOUND DAMPING
ADJUSTERS
Do not turn the adjuster screws more than the given
positions or the adjusters may be damaged.
Always start on full hard when adjusting the damping.
Be sure that the rebound and compression adjusters
are firmly located in a detent, and not between posi-
tions.
The compression and rebound damping can b e
adjusted by turning the adjusters.
DIRECTION H:
DIRECTION S: Decrease the damping force
Turn the compression adjuster clockwise until it stops,
then turn the adjuster counterclockwise.
COMPRESSION ADJUSTER STANDARD POSITION:
2 turns from full hard
Turn the rebound adjuster clockwise until it stops,
then turn the adjuster counterclockwise.
REBOUND ADJUSTER STANDARD POSITION:
2 turns from full hard
REAR SUSPENSION INSPECTION
Support the motorcycle securely and raise the rear
wheel off the ground.
Hold the swingarm and move the rear wheel side-
ways w i t h force see if the wheel bearings are worn.
t o
MAINTENANCE
n
\