Memory Module Installation - Lenovo x3650 M4 BD 5466 Installation And Service Manual

Hide thumbs Also See for x3650 M4 BD 5466:

Table of Contents

Figure 44. Fan installation

1. Pull up the blue handle on the fan cage.

2. Orient the fan so that the fan cable points to the system board.

3. Lower the fan into the fan slot in the server and ensure that is it seated correctly.

4. Connect the fan cable to the connector on the system board. (See "System-board internal

connectors" on page 23).

Note: Make sure the cable passes through the cable clips.

5. Insert the fan cable into the cable retainer clip.

6. Return the blue handle back to its horizontal position.

If you have other devices to install or remove, do so now. Otherwise, go to "Completing the

installation" on page 73.

Step 10. Installing Fan 2A or 3A:

1. Orient the fan so that the fan cable points to the system board.

2. Lower the fan into the fan slot in the server and ensure that is it seated correctly.

3. Connect the fan cable to the connector on the system board. (See "System-board internal

connectors" on page 23).

4. Insert the fan cable into the cable retainer clip.

Note: Make sure the cable passes through the cable clips.

Step 11. If you have other devices to install or remove, do so now. Otherwise, go to "Completing the

installation" on page 73.

Memory module installation

The following notes describe the types of dual inline memory modules (DIMMs) that the server supports

and other information that you must consider when you install DIMMs.

• Confirm that the server supports the DIMM that you are installing, see http://www.lenovo.com/us/en/

serverproven/.

Installing optional devices