3. Connect the other end of the LED signal cable to the hot-swap hard disk drive backplane in
the server.
4. Find the rear hard disk drive detect pin of the hot-swap backplane signal (I
near the system fan cage; then, connect with the rear hard disk drive detect pin of the
LED signal cable from the option package.
Figure 91. Cable routing
5. Connect the other end of the SATA signal and power cables to the power paddle card and
hot-swap hard disk drive backplane in the server. Make sure the labels of both connectors
are matched.
.
Chapter 6
Removing and replacing components
2
C) cable located
165