Lenovo x3650 M4 BD 5466 Installation And Service Manual page 76

Microprocessor Installation Tool A
Figure 47. Microprocessor installation tools
To install an additional microprocessor, complete the following steps:
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
Step 2. Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 32).
Step 4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap rear hard disk
drive cage up" on page 34.
Step 5. Remove the PCI riser-card assembly (see "Removing a PCI riser-card assembly" on page 34.
Step 6. Remove the air baffle (see "Removing the air baffle" on page 36).
Step 7. Locate the second microprocessor socket on the system board (see "System-board internal
connectors" on page 23.
Step 8. Open the microprocessor socket release levers and retainer:
62
Lenovo System x3650 M4 BDInstallation and Service Guide
Installation tool
Microprocessor
Cover
Microprocessor Installation Tool B
Installation tool
Microprocessor