Removing An Adapter From The Pci Riser-Card Assembly - Lenovo x3650 M4 BD 5466 Installation And Service Manual

Hide thumbs Also See for x3650 M4 BD 5466:
Table of Contents

Advertisement

Figure 25. Hot-swap hard disk drive removal
To remove a hot-swap hard disk drive, complete the following steps:
Step 1.
Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
Step 2.
Press the release latch on the side of the drive front.
Step 3.
Grasp the handle and pull the hot-swap drive assembly out of the drive bay.
Note: You might have to reconfigure the disk arrays after you remove a hard disk drive. See the
RAID documentation on the ServeRAID Support CD for information about RAID controllers.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 73.

Removing an adapter from the PCI riser-card assembly

Use this information to remove an adapter from the PCI riser-card assembly.
To remove an adapter from the PCI riser-card assembly, complete the following steps:
Step 1.
Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
Step 2.
Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3.
Remove the server cover (see "Removing the server top cover" on page 247).
Step 4.
Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap rear hard disk
drive cage up" on page 34.
Step 5.
Disconnect any cables from the adapter (make note of the cable routing, in case you reinstall
the adapter later).
Step 6.
Remove the PCI riser-card assembly 1 or 2 (see "Removing a PCI riser-card assembly" on page 34).
Step 7.
The following illustrates the steps for removing an adapter from the PCI riser-card assemblies:
• For PCI riser-card assembly 1:
1. Rotate the retention latch to the open position.
2. Carefully grasp the adapter by its top edge or upper corners, and pull the adapter from the
PCI riser-card assembly.
38
Lenovo System x3650 M4 BDInstallation and Service Guide

Advertisement

Table of Contents
loading

Table of Contents