Lenovo x3650 M4 BD 5466 Installation And Service Manual page 91

If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation"
on page 73.
Rotating the hot-swap rear hard disk drive cage down
Use this information to rotate the optional hot-swap rear hard disk drive cage down.
To rotate the optional hot-swap hard disk drive cage down, complete the following steps.
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
Attention:
1. Make sure you have routed the cables correctly as the following illustration before you rotate
the hot-swap rear hard disk drive cage down. You have to route the cables underneath the
bracket; then, route the cables through the cable retainer clip. Improper cable routing may
damage the cables.
Figure 69. Cable routing
2. Make sure you have routed the cable properly and the cables are not squeezed as the
following illustration before you rotate the hot-swap rear hard disk drive cage down. Improper
cable routing may damage the cables.
.
Chapter 2 Installing optional devices
77