Removing And Replacing Consumable And Structural Parts - Lenovo x3650 M4 BD 5466 Installation And Service Manual

Hide thumbs Also See for x3650 M4 BD 5466:

Table of Contents

Step 17. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices

and the server.

Step 18. Start the Setup utility and reset the configuration.

• Set the system date and time.

• Set the power-on password.

• Reconfigure the server.

See "Using the Setup utility" on page 87.

Step 19. Either update the server with the latest RAID firmware or restore the pre-existing firmware from a

diskette or CD image (see "Updating the firmware " on page 83).

Step 20. Update the UUID (see "Updating the Universal Unique Identifier (UUID)" on page 100).

Step 21. Update the DMI/SMBIOS (see "Updating the DMI/SMBIOS data" on page 102).

Removing and replacing consumable and structural parts

This section provides information for removing and replacing consumable and structural parts in the server.

Replacement of consumable parts and structural parts is your responsibility. If Lenovo installs a consumable

part or structural part at your request, you will be charged for the installation.

The illustrations in this document might differ slightly from the hardware.

Removing the server top cover

Use this information to remove the server top cover.

To remove the server top cover, complete the following steps:

Read the safety information that begins on page "Safety" on page v and "Installation guidelines"

Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.

Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.

If the server has been installed in a rack, press the two release latches on the front of the server

and remove the server out of the rack enclosure.

• Two or more people are required to remove the system from a rack cabinet.

• To completely remove the server from the rack, press the latches on the sides on the slide rails.

Figure 193. Half-out latch

Removing and replacing components