Lenovo x3650 M4 BD 5466 Installation And Service Manual page 181

Figure 93. Cable connection
Note: Make sure the cables are routed in the proper locations without blocking the airflow.
It is recommended to press all the cables downwards to make the cable routing easier.
Secure the cables with any cable retention clips.
• Type 2 - SAS
2
1. Connect the I C signal, SAS signal and power cables to the backplane.
Figure 94. Type 2
2. Insert the hot-swap backplane onto the rear hard disk drive cage (see "Replacing the
hot-swap backplane on the rear hard disk drive cage" on page 225.
3. Connect the other ends of the I
2
C signal, SAS signal and power cables.
.
Chapter 6 Removing and replacing components
167