Dsa Brocade Test Results; Test Results For The Dsa Brocade Test - Lenovo x3650 M4 BD 5466 Installation And Service Manual

• 405-907-000 : BRCM:TestLEDs Test Failed
A failure was detected while verifying operation of the status LEDs.
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Check component firmware level and upgrade if necessary. The installed firmware level can be
found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
2. Rerun the test.
3. If failure remains, refer to "Troubleshooting by symptom" in the system "Installation and Service
Guide" for the next corrective action.
Related links
– IBM Support website
– Latest level of DSA
– Latest level of BMC/IMM

DSA Brocade test results

The following messages can result when you run the Brocade test.

Test results for the DSA Brocade test

The following messages can result when you run the DSA Brocade test.
• 218-000-000 : Brocade:MemoryTest Passed
The test passed.
Recoverable
No
Severity
Event
Serviceable
No
Automatically notify support
No
Appendix C. DSA diagnostic test results
753