Lenovo x3650 M4 BD 5466 Installation And Service Manual page 239

Figure 158. Type 1 - SATA
• Type 2 - SAS
– Disconnect the I
which cable is connected to which connector.
Figure 159. Type 2 - SAS
Step 7. If you are instructed to return the backplane, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the hot-swap backplane on the rear hard disk drive cage
Use this information to replace the hot-swap backplane on the rear hard disk drive cage.
The following illustrations show two different types of hot-swap backplanes.
• Type 1 - SATA
Attention: This backplane has to be cascaded with the front backplane to make the master-slave
connection.
2
C signal, SAS signal and power cables from the backplane. Make note of
.
Chapter 6 Removing and replacing components
225