Lenovo x3650 M4 BD 5466 Installation And Service Manual page 219

Hide thumbs Also See for x3650 M4 BD 5466:

Table of Contents

Start the Setup utility and reset the configuration.

• Set the system date and time.

• Set the power-on password.

• Reconfigure the server.

See "Using the Setup utility" on page 87 for details.

Removing the front USB connector assembly cable

To remove the front USB connector assembly cable that is on the side of the server, complete the following

1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines" on

2. Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.

Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.

3. Remove the server top cover (see "Removing the server top cover" on page 247).

4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap rear hard disk drive

cage up" on page 155.

5. Remove the PCI riser-card assembly (see "Replacing a PCI riser-card assembly" on page 199).

6. Remove the air baffle (see "Removing the air baffle" on page 249).

7. Make note of where the front USB connector assembly cable is attached to the system board; then,

disconnect it.

Figure 131. Disconnecting front USB cable

Removing and replacing components

Troubleshooting