Lenovo x3650 M4 BD 5466 Installation And Service Manual page 183

Step 4. Rotate the hot-swap rear hard disk drive up (see "Rotating the hot-swap rear hard disk drive
cage up" on page 155).
Step 5. Disconnect any cables from the adapter (make note of the cable routing, in case you reinstall
the adapter later).
Step 6. Remove the PCI riser-card assembly 1 or 2 (see "Removing a PCI riser-card assembly" on page
197).
Step 7. The following illustrates the steps for removing an adapter from the PCI riser-card assemblies:
• For PCI riser-card assembly 1:
1. Rotate the retention latch to the open position.
2. Carefully grasp the adapter by its top edge or upper corners, and pull the adapter from the
PCI riser-card assembly.
Figure 96. Adapter removal
Step 8. Place the adapter on a flat, static-protective surface.
Step 9. If you are instructed to return the adapter, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
Replacing the insulator sheet for the power cable
Use this information to replace the insulator sheet for the power cable
To replace the insulator sheet for the power cable, complete the following steps.
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
.
Chapter 6 Removing and replacing components
169