Lenovo x3650 M4 BD 5466 Installation And Service Manual page 57

• Locate the documentation that comes with the adapter and follow those instructions in addition to
the instructions in this section.
• Any high-definition video-out connector or stereo connector on any add-on video adapter is not
supported.
• The server does not support legacy 5 V PCI adapters.
To install an adapter, complete the following steps:
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines"
on page 30.
Step 2. Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 32).
Step 4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap rear hard disk
drive cage up" on page 34.
Step 5. Remove the PCI riser-card assembly (see "Removing a PCI riser-card assembly" on page 34.
Step 6. Determine which expansion slot you will use for the adapter.
Step 7. The following steps illustrate the procedure of installing an adapter on the PCI riser-card assemblies:
• For PCI riser-card assembly 1:
1. Rotate the retention latch to the open position. Insert the adapter into the PCI riser-card
assembly, aligning the edge connector on the adapter with the connector on the PCI
riser-card assembly. Press the edge of the connector firmly into the PCI riser-card assembly.
Make sure that the adapter snaps into the PCI riser-card assembly securely.
2. Rotate the retention latch to the close position. Make sure the retention latch engages
the adapter securely.
.
Chapter 2 Installing optional devices
43