Lenovo x3650 M4 BD 5466 Installation And Service Manual page 175

3
1
Figure 86. Hot-swap rear hard disk drive cage removal
Step 5. Rotate the rear hard disk drive cage outwards
Step 6. Make sure the switch on the rear hard disk drive cage is in the unlock position.
Step 7. Carefully pull the rear hard disk drive cage
Step 8. If you are instructed to return the rear hard disk drive cage, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Replacing the hot-swap rear hard disk drive cage
Use this information to replace the hot-swap rear hard disk drive cage.
To install the rear hot-swap hard disk drive cage, complete the following steps:
Step 1. Read the safety information that begins on page "Safety" on page vand "Installation guidelines"
on page 30.
Step 2. Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
Step 3. Remove the server top cover (see "Removing the server top cover" on page 247.
Step 4. Open the two respective blue latches on the chassis
Step 5. Align the two moveable levers of the rear hard disk drive cage with the two chassis support
brackets. Slide the cage into the chassis support brackets until it firmly sits into place
Step 6. Make sure the switch on the rear hard disk drive cage is in the unlock position.
Step 7. Rotate the cage inward until it firmly sits into place
2
Release latch
3 out of the chassis.
1
2 .
1 .
3 .
.
Chapter 6 Removing and replacing components
2 .
161