Lenovo x3650 M4 BD 5466 Installation And Service Manual page 910

Tape Test Failed. Drive hardware error.
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. Check the tape drive cabling for loose or broken connections or damage to the cable. Replace
the cable if damage is present.
2. Clean the tape drive using the appropriate cleaning media and install new media.
3. Run the test again.
4. Make sure that the drive firmware is at the latest level.
5. Rerun the test after upgrading to the latest firmware level.
6. If the failure remains, refer to "Troubleshooting by symptom" in the system "Installation and
Service Guide" for the next corrective action.
Related links
– IBM Support website
– Latest level of DSA
– Latest level of BMC/IMM
• 264-905-000 : Tape Test Failed
Tape Test Failed. Software error: invalid request.
Recoverable
No
Severity
Error
Serviceable
Yes
Automatically notify support
No
User Response
Complete the following steps:
1. If the system has stopped responding, turn off and restart the system.
2. Check the system firmware level and upgrade if necessary. The installed firmware level can be
found in the DSA Diagnostic Event Log within the Firmware/VPD section for this component.
3. Run the test again.
4. If the system has stopped responding, turn off and restart the system.
5. Make sure that the drive firmware is at the latest level.
896
Lenovo System x3650 M4 BDInstallation and Service Guide