Using The Boot Manager Program; Starting The Backup Server Firmware; The Updatexpress System Pack Installer - Lenovo x3650 M4 BD 5466 Installation And Service Manual

• Remove the battery from the server and then reinstall it. See "Removing the system battery" on page 200
for instructions for removing the battery.
• Clear CMOS data by using the clear CMOS jumper (see "System-board jumpers" on page 26 for more
information).
Attention: Before you change any switch settings or move any jumpers, turn off the server; then,
disconnect all power cords and external cables. See the safety information that begins on page "Safety"
on page v. Do not change settings or move jumpers on any system-board switch or jumper blocks
that are not shown in this document.
Clearing CMOS data does not affect the administrator password.
Administrator password
If an administrator password is set, you must type the administrator password for access to the full Setup
utility menu. You can use any combination of 6 to 20 printable ASCII characters for the password.
Attention: If you set an administrator password and then forget it, there is no way to change, override,
or remove it. You must replace the system board.

Using the Boot Manager program

Use this information for the Boot Manager.
The Boot Manager program is a built-in, menu-driven configuration utility program that you can use to
temporarily redefine the first startup device without changing settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
Step 1. Turn off the server.
Step 2. Restart the server.
When the prompt <F12> Select Boot Device is displayed, press F12. If a bootable USB mass
Step 3.
storage device is installed, a submenu item (USB Key/Disk) is displayed.
Step 4. Use the Up arrow and Down arrow keys to select an item from the Boot Selection Menu and
press Enter.
The next time the server starts, it returns to the startup sequence that is set in the Setup utility.

Starting the backup server firmware

Use this information to start the backup server firmware.
The system board contains a backup copy area for the server firmware. This is a secondary copy of the
server firmware that you update only during the process of updating the server firmware. If the primary copy
of the server firmware becomes damaged, use this backup copy.
To force the server to start from the backup copy, turn off the server; then, place the J2 jumper in the
backup position (pins 2 and 3).
Use the backup copy of the server firmware until the primary copy is restored. After the primary copy is
restored, turn off the server; then, move the J2 jumper back to the primary position (pins 1 and 2).

The UpdateXpress System Pack Installer

The UpdateXpress System Pack Installer detects supported and installed device drivers and firmware in the
server and installs available updates.
.
Chapter 3 Configuration information and instructions
93