Applying The Load Balancing Policy - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
The system view is displayed.
Step 2 Run:
load-balance policy policy-name
A load balancing policy is created and the load balancing policy view is displayed.
Up to 1024 load balancing policies can be created.
By default, no load balancing policy is configured.
Step 3 Run:
l3classifier l3classifier-name
A Layer 3 classifier is bound to the load balancing policy.
A load balancing policy can be bound to up to eight Layer 3 classifiers to support a maximum
of 1024 service applications.
By default, no Layer 3 classifier is bound to a load balancing policy.
----End

6.4.14 Applying the Load Balancing Policy

A load balancing policy takes effect only after being applied.
Context
A load balancing policy can be applied to only XGE sub-interfaces or Eth-Trunk sub-interfaces
on the SPU.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subnumber
The sub-interface view is displayed.
Step 3 Run:
service load-balance policy policy-name
The load balancing policy is applied to an XGE sub-interface or an Eth-Trunk sub-interface.
After the load balancing policy is applied, the SPU takes actions defined in the load balancing
policy for the VLAN packets matching the Layer 3 classifier bound to the load balancing policy
on the XGE sub-interface.
By default, no load balancing policy is applied to an XGE sub-interface or an Eth-Trunk sub-
interface.
Step 4 (Optional) Run:
service load-balance arp-response nat address-group group-index
The NAT address pool is enabled to respond to ARP requests on the sub-interface.
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Load Balancing Configuration
265