Huawei quidway s7700 Configuration Manual page 34

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
15. Run:
16. Run:
17. Run:
18. Run the corresponding command according to the link type to add the interface to the
19. Run:
20. Run:
Step 2 Export data flows:
1.
2.
3.
4.
Issue 01 (2011-07-15)
quit
Exit from the VLANIF interface view.
interface xgigabitethernet interface-number
The view of the virtual XGE interface on the S7700 is displayed.
port link-type { access | hybrid | trunk }
The link type of the interface is configured.
inbound VLAN.
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access interface is added.
l For the Hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
command to configure the VLAN to which the Trunk interface is added.
quit
Exit from the XGE interface view.
ip route-static ip-address { mask | mask-length } vlanif vlan-id [ nexthop-
address ]
The static route to the destination IP address of traffic is configured. Here, ip-address
indicates the destination IP address; mask or mask-length indicates the mask of the
destination IP address; vlan-id indicates the ID of the inbound VLAN created in step
1.11; nexthop-address indicates the IP address configured in Configuring Layer 3 Flow
Import on SPU If Interfaces Are Not Aggregated
Run:
vlan vlan-id
An outbound VLAN is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface xgigabitethernet interface-number
The view of the virtual XGE interface on the S7700 is displayed.
Run the corresponding command according to the link type to add the interface to the
outbound VLAN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step 1.5.
Step
23