Huawei quidway s7700 Configuration Manual page 18

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
7.
Step 2 Export data flows:
1.
2.
3.
4.
5.
6.
Step 3 Configure an Eth-Trunk:
1.
Issue 01 (2011-07-15)
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access interface is added.
l For the Hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all command
to configure the VLAN to which the Trunk interface is added.
Run:
quit
Exit from the interface view.
Run:
vlan vlan-id
An outbound VLAN is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface interface-type interface-number
The LPU interface (this interface forwards the traffic processed by the SPU to the LPU)
view is displayed.
Run:
port link-type { access | hybrid | trunk }
The link type of the interface is configured.
Run the corresponding command according to the link type to add the interface to the
outbound VLAN:
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access interface is added.
l For the Hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
command to configure the VLAN to which the Trunk interface is added.
Run:
quit
Exit from the interface view.
Run:
interface eth-trunk trunk-id
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
7