Huawei quidway s7700 Configuration Manual page 19

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
2.
3.
4.
----End
Configuring Layer 2 Flow Import on SPU If Interfaces Are Aggregated
This topic describes how to configure Layer 2 flow import on the SPU in interface aggregation
mode.
Context
Procedure
Step 1 Configure an Eth-Trunk:
1.
2.
3.
Issue 01 (2011-07-15)
The Eth-Trunk interface view is displayed.
Run:
trunkport xgigabitethernet { interface-number1 [ to interface-number2 ] }
&<1-8>
Two virtual interfaces on the S7700 are aggregated as the Eth-Trunk interface.
Run:
port link-type { access | hybrid | trunk }
The link type of the Eth-Trunk interface is configured.
Run the corresponding command according to the link type to add the Eth-Trunk interface
to the VLANs created in step
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access Eth-Trunk interface is added.
l For the Hybrid Eth-Trunk interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
command to configure the VLAN to which the Trunk Eth-Trunk interface is added.
NOTE
To facilitate description, the direction of forwarding traffic from the LPU to the SPU is the incoming
direction of traffic; the direction of forwarding traffic from the SPU to the LPU is the outgoing direction
of traffic.
Run:
system-view
The system view is displayed.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
trunkport xgigabitethernet { interface-number1 [ to interface-number2 ] }
&<1-8>
Two virtual interfaces on the SPU are aggregated as the Eth-Trunk interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 1.2 and step Step
1 SPU Pre-Configuration
2.1:
8