Configuring An Acl - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Step 3 Run the following command as required.
l Run:
l Run:
l Run:
l Run:
By default, the action is forward.
----End

6.3.8 Configuring an ACL

This section describes how to configure an ACL to identify the traffic of various services.
Context
In egress link load balancing, the SPU can use only the source IP address, destination IP address,
protocol type, source port number and destination port number to define ACL rules.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
acl [ number ] [ match-order { config | auto } ]
An ACL is created and the ACL view is displayed.
In egress link load balancing, the value of number ranges from 3000 to 3999. That is, advanced
ACLs are used.
A Layer 3 classifier can be bound to only one ACL. If the ACL is configured repeatedly, the
latest ACL takes effect.
By default, no ACL is created.
Step 3 (Optional) Run:
step step-value
The step between ACL rule IDs is set.
By default, the step between ACL rule IDs is 5.
Step 4 Run the following command as required:
Issue 01 (2011-07-15)
drop
The action is set to drop.
forward
The action is set to forward.
group master-group-name [ backup backup-group-name ]
The action is set to load balance.
stickygroup stickygroup-name
The action is set to the sticky operation.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Load Balancing Configuration
240