Checking The Configuration; Configuring Server Load Balancing; Establishing The Configuration Task - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Up to eight NAT address pools can be enabled to respond to ARP requests on a sub-interface.
----End

6.3.13 Checking the Configuration

After egress link load balancing is configured successfully, check whether the configurations
are correct and valid.
Procedure
l
l
l
l
l
l
l
l
l
l
----End

6.4 Configuring Server Load Balancing

In the networking where multiple servers are deployed such as the data center, you can configure
server load balancing to load balance network services among multiple servers for processing.
In this manner, service processing capabilities of servers are improved.

6.4.1 Establishing the Configuration Task

Before configuring server load balancing, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This helps you complete the
configuration task quickly and accurately.
Applicable Environment
In the networking such as the data center, a server needs to process a large number of user
requests. The processing capabilities of a single server is limited and is bound to be the
Issue 01 (2011-07-15)
Run the display load-balance member [ name member-name | all ] command to check
the configuration of the load balancing member.
Run the display load-balance probe [ name probe-name [ group name group-name
member name member-name ] | all ] command to check the configuration of the probe.
Run the display load-balance group [ name group-name | all ] command to check the
configuration of the load balancing group.
Run the display load-balance group name group-name member name member-name
[ verbose ] command to check the configuration of the load balancing member instance.
Run the display load-balance l7classifier [ name l7classifier-name | all ] command to
check the configuration of the Layer 7 classifier.
Run the display load-balance action [ name action-name | all ] command to check the
configuration of the load balancing action profile.
Run the display load-balance l3classifier [ name l3classifier-name | all ] command to
check the configuration of the Layer 3 classifier.
Run the display load-balance policy [ name policy-name | all ] command to check the
configuration of the load balancing policy.
Run the display load-balance parameter connection [ name connection-name | all ]
command to check the configuration of the connection parameter profile.
Run the display load-balance parameter http [ name http-name | all ] command to check
the configuration of the HTTP parameter profile.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Load Balancing Configuration
245