Huawei quidway s7700 Configuration Manual page 165

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Prerequisite
l
l
Context
Before adding an AP to the AC, you can configure a radio and VAP for the AP. When the type
and serial number (SN) or MAC address of an AP match those configured on the AC:
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
wlan
The WLAN view is displayed.
Step 3 (Optional) Run:
ap-license ap-license number
The number of AP licenses is set. An AP license controls the number of APs supported by an
AC.
Step 4 (Optional) Run:
ap-type { id type-id | type ap-type }
An AP type is added.
The system defines the following default AP types: WA601, WA631, WA651, WA602, WA632,
WA652, WA603SN, WA603DN, WA653SN and WA633SN.
Step 5 Run:
ap-update mode { ftp-mode | ac-mode }
The AP upgrade mode is configured.
The system supports the AC mode and FTP mode. By default, the AC mode is used.
Step 6 Run:
ap-update update-filename filename ap-type type-id
The AP upgrade file is specified.
Issue 01 (2011-07-15)
Basic AC attributes have been configured according to
Attributes.
The AP is connected to the AC correctly.
If the AP is in the whitelist configured by using the ap-whitelist command, it starts to work
and provides WLAN services immediately.
If the AP is not in the whitelist, run the ap-confirm command to confirm the AP identity
so that the AP can go online.
NOTE
Currently, only WA603SN, WA603DN, WA653SN, and WA633SN can connect to an AC.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5.1.3 Configuring Basic AC
*
5 WLAN Configuration
154