Huawei quidway s7700 Configuration Manual page 223

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Item
Radio profile of an AP
Management VLAN of an AP
AP region
Service VLAN of an AP
SwitchVLAN
AC's management IP address
AC carrier ID/AC ID
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Issue 01 (2011-07-15)
Configure the Switch and the AC to enable APs to communicate with the AC.
Configure basic AC attributes, including the AC ID, carrier ID, and source interface that
the AC uses to communicate with APs.
Set the AP authentication mode and add APs to an AP region.
Configure VAPs and deliver VAP parameters. To configure a VAP:
l Configure a WLAN-ESS interface and bind it to a service set so that radio packets can
be sent to the WLAN service module after reaching the AC.
l Create a WMM profile and set attributes for the profile. Create a radio profile and bind
it to the WMM profile to first meet voice or video service requirements of users.
l Create a traffic profile and set attributes for the profile to first meet communication
requirements of the VIP customer when the network bandwidth is insufficient.
l Create a security profile to control STA access.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
l SSID: huawei-3
l Traffic profile: huawei
l VLAN: 203
l SSID: huawei-4
l Traffic profile: huawei
l VLAN: 204
l SSID: huawei-5
l Traffic profile: huawei-vip
l VLAN: 205
l AP1 radio profile (huawei) and WMM profile
(huawei)
l AP2 radio profile (huawei-vi) and WMM profile
(huawei-vi)
VLAN 100, which is assigned by the Switch
l AP1: 101
l AP2: 102
l AP1: VLAN 101 and VLAN 102
l AP2: VLAN 203, VLAN 204, and VLAN 205
VLAN 100/101/102/203/204/205
VLANIF 100: 192.168.0.1/24
other/1
5 WLAN Configuration
212