Huawei quidway s7700 Configuration Manual page 29

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
10. Run:
11. Run:
12. Run:
13. Run:
14. Run:
15. Run:
16. Run:
Step 2 Export data flows:
1.
2.
Step 3 Configure an Eth-Trunk:
1.
Issue 01 (2011-07-15)
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
command to configure the VLAN to which the Trunk interface is added.
quit
Exit from the interface view.
vlan vlan-id
An inbound VLAN is created and the VLAN view is displayed.
quit
Exit from the VLAN view.
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed. The value of
vlan-id in this step is the same as that of vlan-id in step
ip address ip-address { mask| mask-length}
The IP address of the VLANIF interface is set.
quit
Exit from the VLANIF interface view.
ip route-static ip-address { mask | mask-length } vlanif vlan-id [ nexthop-
address ]
The static route to the destination IP address of traffic is configured. Here, ip-address
indicates the destination IP address; mask or mask-length indicates the mask of the
destination IP address; vlan-id indicates the ID of the inbound VLAN created in step
1.11; nexthop-address indicates the IP address configured in Configuring Layer 3 Flow
Import on SPU If Interfaces Are Aggregated
Run:
vlan vlan-id
An outbound VLAN is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step 1.11.
Step 2.4.
Step
18