Huawei quidway s7700 Configuration Manual page 191

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Table 5-1 Data plan
Item
WLAN service
Management VLAN for APs
AP region
Service set
User VLAN
VLANs on the Switch
AC carrier ID/AC ID
Management IP address of the AC VLANIF interface address: 192.168.0.1/24
Address pool for APs
Gateway address for APs
DHCP server
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Issue 01 (2011-07-15)
Configure the Switch and the AC to enable APs to communicate with the AC.
Configure basic AC attributes, including the AC ID, carrier ID, and source interface that
the AC uses to communicate with APs. Configure the AC as a DHCP server.
Set the AP authentication mode and add APs to an AP region.
Configure VAPs and deliver VAP parameters so that STAs can access the WLAN.
To configure a VAP:
(1) Configure a WLAN-ESS interface and bind it to a service set so that radio packets
can be sent to the WLAN service module after reaching the AC.
(2) Configure a radio profile on the Switch and bind it to a radio to enable STAs to
communicate with the AP.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Data
WEP open system authentication and no encryption
VLAN 100, which is assigned by the Switch
AP1: 101
AP2: 102
l Name: huawei-1
l SSID: huawei-1
l WLAN virtual interface: WLAN-ESS 0
l Data forwarding mode: direct forwarding
l Name: huawei-2
l SSID: huawei-2
l WLAN virtual interface: WLAN-ESS 1
l Data forwarding mode: direct forwarding
AP1: VLAN 101
AP2: VLAN 102
VLAN 100/101/102
other/1
192.168.0.2–192.168.0.254/24
192.168.0.1/24 (IP address of the AC)
AC
5 WLAN Configuration
180