Configuring Layer 3 Flow Import If Interfaces Are Aggregated - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Pre-configuration Tasks
Check that the SPU is installed on the S7700.
Data Preparation
To configure Layer 3 flow import, you need the following data.
No.
1
2
3
4

1.4.2 Configuring Layer 3 Flow Import If Interfaces Are Aggregated

When firewalls, load balancing, and IPSec are used, you are advised to aggregate two groups of
virtual XGE service interfaces on the S7700 and SPU as Eth-Trunk interfaces to increase
bandwidth on interfaces.
Configuring Layer 3 Flow Import on S7700 If Interfaces Are Aggregated
This topic describes how to configure Layer 3 flow import on the S7700 in interface aggregation
mode.
Issue 01 (2011-07-15)
Figure 1-5 Importing flows at Layer 3 if interfaces are not aggregated
GE3/0/0 VLANIF1051 14.14.1.2/24
VLANIF1060
13.1.1.1/24
GE3/0/0
VLAN1052
Data
Number of the Eth-Trunk interface
Ethernet interface number and sub-interface number
IP address and mask of the sub-interface
Range of IDs of the VLANs to which interfaces belong
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
XGE5/0/0
XGE0/0/1.1
VLAN1052
14.14.1.1/24
XGE0/0/1.2
12.12.1.1/24
Switch
1 SPU Pre-Configuration
16