Configuring A Vap Qos Policy - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Checking the Configuration
Run the display wmm-profile { all | id profile-id | name profile-name } command to view the
configuration of a WMM profile.

5.3.4 Configuring a VAP QoS Policy

To apply the priority mapping and traffic suppression functions to a virtual AP (VAP), create a
traffic profile and bind the traffic profile to a service set.
Applicable Environment
To forward an 802.11 packet sent from a STA to an Ethernet network, an AP converts the 802.11
packet into an 802.3 packet. The AP may retain the packet priority or change the packet priority
according to the VAP configuration to provide differentiated QoS services.
Pre-configuration Tasks
Before configuring a VAP QoS policy, complete the following tasks:
l
l
Data Preparation
To configure a VAP QoS policy, you need the following data.
No.
1
2
3
4
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
wlan
The WLAN view is displayed.
Step 3 Run:
traffic-profile { name profile-name | id profile-id }
A traffic profile is configured.
Issue 01 (2011-07-15)
Configuring basic AC attributes according to
Connecting an AP to an AC correctly
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5.1.3 Configuring Basic AC Attributes
Data
Traffic profile name or traffic profile ID
(Optional) Mappings from user priorities to 802.1p priorities
and mappings from 802.1p priorities to user priorities
(Optional) Packet rate limit
(Optional) Tunnel priority value
5 WLAN Configuration
*
207