Huawei quidway s7700 Configuration Manual page 207

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Step 3 Configure user isolation.
l
l
----End
Checking the Configuration
l
Check whether user isolation is enabled in service set 1.
<Quidway> display service-set id 1
----------------------------------------------------------------------------
Service-set ID
Service-Set name
SSID
Hide SSID
User isolate
Type
Maximum number of user
Association timeout(min) : 5
Traffic profile name
Security profile name
User profile name
Wlan-ess interface num
Igmp mode
Forward mode
Service-vlan
----------------------------------------------------------------------------
Check whether user isolation is enabled in service set with the SSID of l00129796_93002.
Issue 01 (2011-07-15)
If data is directly forwarded between the AP and AC, user isolation must be configured in
a service set.
1. Run:
service-set { name service-set-name | id service-set-id }
A service set is configured.
2. Run:
user-isolate
User isolation is configured.
If data is forwarded between the AP and AC through a tunnel, user isolation must be
configured in a service set and on a WLAN-ESS interface.
1. Run:
service-set { name service-set-name | id service-set-id }
A service set is configured.
2. Run:
user-isolate
User isolation is configured.
3. Run:
quit
Return to the system view.
4. Run:
interface wlan-ess wlan-ess-number
The WLAN-ESS interface view is displayed.
5. Run:
port-isolate enable
Port isolation is enabled.
Run the display service-set { all | id service-set-id | name service-set-name | ssid ssid }
command to check whether user isolation is enabled in service sets.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: 1
: lw2
: l00129796_93002
: disable
: enable
: service
: 32
: lw
: lw
: -
: 6
: off
: direct-forward
: 106
5 WLAN Configuration
*
*
196