Huawei quidway s7700 Configuration Manual page 28

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Context
Procedure
Step 1 Import data flows:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Issue 01 (2011-07-15)
NOTE
To facilitate description, the direction of forwarding traffic from the LPU to the SPU is the incoming
direction of traffic; the direction of forwarding traffic from the SPU to the LPU is the outgoing direction
of traffic.
Run:
system-view
The system view is displayed.
Run:
vlan vlan-id
A VLAN is created and the VLAN view is displayed.
Run:
quit
Exit from the VLAN view.
Run:
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed. The value of
vlan-id in this step is the same as that of vlan-id in
Run:
ip address ip-address { mask| mask-length}
The IP address of the VLANIF interface is set. This IP address and the source IP address
of traffic share the same network segment.
Run:
quit
Exit from the VLANIF interface view.
Run:
interface interface-type interface-number
The LPU interface (this interface forwards traffic to the SPU for processing) view is
displayed.
Run:
port link-type { access | hybrid | trunk }
The link type of the interface is configured.
Run the corresponding command according to the link type to add the interface to the VLAN
created in step Step 1.2:
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access interface is added.
l For the Hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
stepStep 1.2.
17