Huawei quidway s7700 Configuration Manual page 33

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
5.
6.
7.
8.
9.
10. Run:
11. Run:
12. Run:
13. Run:
14. Run:
Issue 01 (2011-07-15)
A VLANIF interface is created and the VLANIF interface view is displayed. The value of
vlan-id in this step is the same as that of vlan-id in step
Run:
ip address ip-address { mask| mask-length}
The IP address of the VLANIF interface is set. This IP address and the source IP address
of traffic shares the same network segment.
Run:
quit
Exit from the VLANIF interface view.
Run:
interface interface-type interface-number
The LPU interface (this interface forwards traffic to the SPU for processing) view is
displayed.
Run:
port link-type { access | hybrid | trunk }
The link type of the interface is configured.
Add the interface to the VLAN created in
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access interface is added.
l For the Hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
command to configure the VLAN to which the Trunk interface is added.
quit
Exit from the interface view.
vlan vlan-id
An inbound VLAN is created and the VLAN view is displayed.
quit
Exit from the VLAN view.
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed. The value of
vlan-id in this step is the same as that of vlan-id in step
ip address ip-address { mask| mask-length}
The IP address of the VLANIF interface is set.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 1.2.
Step 1.2 according to the link type of the interface.
Step 1.11.
1 SPU Pre-Configuration
22