Configuring A Link - Huawei quidway s7700 Configuration Manual

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
fail-interval interval
The interval for a probe to detect that a link member is Down is set.
After the link becomes invalid, the SPU sends probing packets at this interval to detect link
recovery. This interval must be greater than the timeout interval of a probe.
By default, the interval for a probe to detect that a link member is Down is 60s.
Step 9 (Optional) Run:
fail-retrycount times
The retry count for a probe to detect link recovery is set.
By default, the retry count for a probe to detect link recovery is 3.
----End

6.3.4 Configuring a Link

This section describes how to create a link and set link parameters, including the IP address of
the gateway corresponding to the link, connection quantity limit, bandwidth limit, bandwidth
threshold, weight, and priority.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
load-balance member member-name
A link is created and the load balancing member view is displayed.
Up to 1024 links can be created.
By default, no link is configured.
Step 3 (Optional) Run:
description text
The description of a link is configured.
By default, no description is configured for a link.
Step 4 Run:
ip address ip-address
The IP address of the gateway corresponding to the link is set.
By default, the IP address of the gateway corresponding to the link is not set.
Step 5 (Optional) Run:
rate-limit { bandwidth { inbound | outbound } band-limit [ threshold
value ] | connection conn-limit }
The bandwidth limit, bandwidth threshold for receiving new traffic, and connection rate limit
of the link are set.
Issue 01 (2011-07-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Load Balancing Configuration
threshold-
235