Huawei quidway s7700 Configuration Manual page 35

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
5.
----End
Configuring Layer 3 Flow Import on SPU If Interfaces Are Not Aggregated
This topic describes how to configure Layer 3 flow import on the SPU in non-aggregation mode.
Context
Procedure
Step 1 Import data flows:
1.
2.
3.
4.
5.
Issue 01 (2011-07-15)
l Run the port default vlan vlan-id command to configure the default VLAN to which
the Access interface is added.
l For the Hybrid interface:
– Run the port hybrid tagged vlan { vlan-id1 [ to vlan-id2] }&<1-10> command to
add the Hybrid interface to the VLAN in tagged mode.
– Run the port hybrid untagged vlan { vlan-id1 [ to vlan-id2 ] }&<1-10> command
to add the Hybrid interface to the VLAN in untagged mode.
l Run the port trunk allow-pass vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
command to configure the VLAN to which the Trunk interface is added.
Run:
quit
Exit from the XGE interface view.
NOTE
To facilitate description, the direction of forwarding traffic from the LPU to the SPU is the incoming
direction of traffic; the direction of forwarding traffic from the SPU to the LPU is the outgoing direction
of traffic.
Run:
system-view
The system view is displayed.
Run:
interface xgigabitethernet interface-number.subinterface-number
The sub-interface view is displayed. Traffic is imported to the SPU through this sub-
interface.
Run:
control-vid vid dot1q-termination
The index of the ID of the VLAN to which the sub-interface belongs and encapsulation
mode of the sub-interface are configured.
Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ]
The allowed VLAN on the dot1q sub-interface is configured as the VLAN configured in
Configuring Layer 3 Flow Import on S7700 If Interfaces Are Not Aggregated
Run:
ip address ip-address { mask | mask-length } [ sub ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step 1.11.
24