Huawei quidway s7700 Configuration Manual page 168

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Result
The MAC address or SN of the AP connected to the AC is in the whitelist, so the AP enters the
normal state directly.
Run the display ap { all | id ap-id | by-mac ap-mac | by-sn ap-sn } command. The command
output shows that the AP is in normal state.
Configuring AP Discovery and Confirming the AP Identity
After the AP whitelist and AP authentication mode are configured on the AC, the AC adds an
AP to the list of unauthorized APs if the AP is not in the whitelist. After you confirm the identity
of the AP, the AP can function properly.
Prerequisite
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
wlan
The WLAN view is displayed.
Step 3 (Optional) Run:
ap-type { id type-id | type ap-type }
An AP type is added.
The system defines the following default AP types: WA601, WA631, WA651, WA602, WA632,
WA652, WA603SN, WA603DN, WA653SN and WA633SN.
Step 4 Run:
ap-auth-mode
The AP authentication mode is set to MAC address authentication or SN authentication.
The default authentication mode is MAC address authentication.
Step 5 Run:
ap-confirm { all | { mac ap-mac | sn ap-sn } [ id ap-id ] }
The AP identity is confirmed and the AP can go online.
After the AP identity is confirmed, the MAC address or SN of the AP is added to the whitelist.
The AP is added to the default region and bound to the default AP profile, and its attributes are
set to default values. The AP then enters the normal state.
----End
Issue 01 (2011-07-15)
Basic AC attributes have been configured according to
Attributes.
The AP is connected to the AC correctly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5.1.3 Configuring Basic AC
*
5 WLAN Configuration
157