Huawei quidway s7700 Configuration Manual page 167

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
Configuring AP Discovery
After you configure the AP whitelist and AP authentication mode on an AC, an AP can be
discovered by the AC and go online if it is in the whitelist.
Prerequisite
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
wlan
The WLAN view is displayed.
Step 3 (Optional) Run:
ap-type { id type-id | type ap-type }
An AP type is added.
The system defines the following default AP types: WA601, WA631, WA651, WA602, WA632,
WA652, WA603SN, WA603DN, WA653SN and WA633SN.
Step 4 Run:
ap-auth-mode auth-mode
The AP authentication mode is configured. The SPU supports MAC address authentication, SN
authentication, and none authentication.
The default authentication mode is MAC address authentication.
Step 5 Run:
ap-whitelist { mac ap-mac1 [ to ap-mac2 ] | sn ap-sn1 [ to ap-sn2 ] }
One or more AP MAC addresses or SNs are added to the whitelist.
----End
Issue 01 (2011-07-15)
Basic AC attributes have been configured according to
Attributes.
The AP is connected to the AC correctly.
NOTE
l If the AP authentication mode is set to no-auth, APs of the specified type can go online automatically.
After an AP goes online, it is added to the default region and bound to the default AP profile, and its
attributes are set to default values. The AP then enters the normal state.
l If the AP authentication mode is set to sn-auth or mac-auth, APs of the specified type can go online
automatically if their MAC addresses or SNs are in the whitelist. After an AP goes online, it is added
to the default region and bound to the default AP profile, and its attributes are set to default values.
The AP then enters the normal state.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5.1.3 Configuring Basic AC
*
5 WLAN Configuration
156