Huawei quidway s7700 Configuration Manual page 185

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
The rate limit for upstream or downstream packets is set for a single STA or all STAs associated
with a VAP.
Step 7 (Optional) Run either of the following commands to set designated priorities or priority
mappings for upstream tunnels:
l
l
----End
Configuring a WLAN Service Set
A service set defines key service parameters. After creating a service set, bind a security profile
and a traffic profile to the service set.
Prerequisite
A security profile and a traffic profile have been created.
Context
A service set defines key service parameters. After the service set is bound to a specified radio
on an AP, the service parameters are applied to a WLAN service entity, namely, a virtual access
point (VAP).
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface wlan-ess wlan-ess-number
A WLAN-ESS interface is created.
Step 3 Run:
wlan
The WLAN view is displayed.
Step 4 Run:
security-profile { name profile-name | id profile-id }
A security profile is created.
Step 5 Run:
quit
Return to the system view.
Step 6 Run:
traffic-profile { name profile-name | id profile-id }
Issue 01 (2011-07-15)
tunnel-priority up designate { tos | 8021p } priority-value
tunnel-priority up map { tos-tos | tos-8021p | 8021p-tos | 8021p-8021p } value0
value1 value2 value3 value4 value5 value6 value7
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 WLAN Configuration
*
*
174