Huawei quidway s7700 Configuration Manual page 31

Quidway S7700 Smart Routing Switch
Configuration Guide - SPU
4.
Step 2 Import data flows:
1.
2.
3.
4.
5.
6.
Step 3 Export data flows:
1.
2.
3.
Issue 01 (2011-07-15)
Two virtual interfaces on the SPU are aggregated as the Eth-Trunk interface.
Run:
quit
Exit from the Eth-Trunk interface view.
Run:
interface eth-trunk trunk-id.subtrunk-id
The Eth-Trunk sub-interface view is displayed. Traffic is imported to the SPU through the
Eth-Trunk sub-interface.
Run:
control-vid vid dot1q-termination
The index of the ID of the VLAN to which the Eth-Trunk sub-interface belongs and
encapsulation mode of the Eth-Trunk sub-interface are configured.
Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ]
The allowed VLAN on the sub-interface is configured as the VLAN configured in
Configuring Layer 3 Flow Import on S7700 If Interfaces Are Aggregated
Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the Eth-Trunk sub-interface is configured. The Eth-Trunk sub-interface
is in the same network segment with the VLANIF interface configured in Configuring
Layer 3 Flow Import on S7700 If Interfaces Are Aggregated
Run:
arp broadcast enable
The ARP broadcast function on the Eth-Trunk sub-interface is enabled.
When you enable or disable the ARP broadcast function on a sub-interface, the routing
status on the sub-interface becomes Down and then Up. This may result in route flapping
on the entire network, affecting the normal operation of services.
Run:
quit
Exit from the Eth-Trunk sub-interface view.
Run:
interface eth-trunk trunk-id.subtrunk-id
The Eth-Trunk sub-interface view is displayed. Traffic is exported from the SPU through
the Eth-Trunk sub-interface.
Run:
control-vid vid dot1q-termination
The index of the ID of the VLAN to which the Eth-Trunk sub-interface belongs and
encapsulation mode of the sub-interface are configured.
Run:
dot1q termination vid low-pe-vid [ to high-pe-vid ].
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 SPU Pre-Configuration
Step 1.11.
Step 1.14.
20