Checking The Configuration; Configuring Layer 2 Multicast Cac - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast

2.5.3 Checking the Configuration

Prerequisite
The configurations of a static multicast MAC address are complete.
Procedure
l
l
----End
Example
# View static multicast MAC address entries in VLAN 10.
<Quidway> display mac-address multicast vlan 10
--------------------------------------------------------------------
MAC Address
--------------------------------------------------------------------
0111-1111-2222
--------------------------------------------------------------------
Total Group(s) : 1
# View the number of static multicast MAC address entries in VLAN 10.
<Quidway> display mac-address multicast vlan 10 total-number
Total number of mac-address : 3

2.6 Configuring Layer 2 Multicast CAC

This section describes how to configure the Layer 2 multicast CAC function.
As shown in
IGMP snooping is deployed on the UPE to implement multicast CAC on the VLAN, allowing
the UPE to control the number of IPTV channels requested by the downstream DSLAM or
switch.
Issue 01 (2011-07-15)
Run the display mac-address multicast [ mac-address ] [ vlan vlan-id ] command to check
the configured static multicast MAC addresses.
Run the display mac-address multicast [ vlan vlan-id ] total-number command to check
the number of configured static multicast MAC addresses.
VLANID
10
Figure 2-1, the UPE is connected to downlink devices through a Layer 2 network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 IGMP Snooping Configuration
Out-Interface
GigabitEthernet1/0/1
GigabitEthernet1/0/2
2 port(s)
31